HP Drivetech Air Suspension Kit for Seat Leon 4WD – 1M (1999-2006)
HP Drivetech Air Suspension Kit for Seat Leon 4WD – 1M (1999-2006)
£2,320.00 inc VAT
Made to Order (contact us for lead time)
){kind=link}
H&R Deep Coilover Kit for Audi 80 B4 Saloon + Estate 4WD 50-100mm:
Suspension, H&R Coilover Suspension, Shop by Car, Audi, 80, H&R Coilovers
Audi H&R DEEP Coilovers – Audi 80 B4 Saloon + Estate 4WD ( 4cylinder models ) for 5+6 cylinder models please check GFW50491-2-14SC
It is important to check the size of the bolts which secure the dampers as these are either M12 or M14. Please contact us for your requirements of the lowering range and vehicle type at [email protected]
Lowering : 50-100mm
£1,959.99 inc VAT
| This is a custom made “Deep” version coilover kit made to order. |
£1,959.99 inc VAT
H&R Race Coilover Kit for Audi TT 8J 60-120mm: Inc. adjustable damping for oe top mounts
Suspension, H&R Coilover Suspension, Shop by Car, Audi, TT / TTS/ TTRS, H&R Coilovers
£2,207.99 inc VAT
H&R Deep Coilover Kit for Audi S1 8X Quattro
Suspension, H&R Coilover Suspension, Shop by Car, Audi, H&R Coilovers
H&R Deep Coilover Kit for Audi S1 8X Quattro ( 170 KW ) 2014>
for vehicles without electronic suspension control
Lowered front axle from [mm]: 55 • Lowering front axle up to [mm]: 70
Lowered rear axle from [mm]: 40 • Lowered rear axle up to [mm]: 85
This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary.
Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality.
Note: The picture may differ from the delivered product
£1,429.99 inc VAT
This version offers more lowering range than the normal H&R version.
The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited.
After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions.
If necessary, the vehicle ride height must be adjusted higher. In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated).
StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
£1,429.99 inc VAT