H&R Height Adjustable Spring System Audi RS4 Avant 2017> – 23012-2
H&R Height Adjustable Spring System Audi RS4 Avant 2017> – 23012-2
£POA
Type B8 (B9), 4WD, only vehicles with RS Sport Suspension Plus but without adaptive damper control
H&R Deep RSS Coilover Kit for Audi B7/QB6 S4 + RS4 50-120mm inc DRC delete kit.
Suspension, H&R Coilover Suspension, Shop by Car, Audi, A4 / S4 / RS4, H&R Coilovers
The Race Kits utilise Bilstein’s renowned monotube damper technology, the same technology used by BMW’s official DTM teams. The steel dampers benefit from a triple-galvanised coating as well as H&R’s own special protective layer to hold back corrosion. Combined with H&R’s race-spec modular springs these coilovers deliver maximum performance. All applications are height adjustable and some applications have an extra-cost option for 18 damper settings.
Lowering Range for this coilover 50-120mm
Kits available as fixed damping or with hardness adjustment.
Please contact us [email protected] for further queries.
£1,915.00 – £1,965.00 inc VAT
£1,915.00 – £1,965.00 inc VAT
H&R Deep Coilover Kit for Audi S1 8X Quattro
Suspension, H&R Coilover Suspension, Shop by Car, Audi, H&R Coilovers
H&R Deep Coilover Kit for Audi S1 8X Quattro ( 170 KW ) 2014>
for vehicles without electronic suspension control
Lowered front axle from [mm]: 55 • Lowering front axle up to [mm]: 70
Lowered rear axle from [mm]: 40 • Lowered rear axle up to [mm]: 85
This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary.
Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality.
Note: The picture may differ from the delivered product
£1,429.99 inc VAT
This version offers more lowering range than the normal H&R version.
The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited.
After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions.
If necessary, the vehicle ride height must be adjusted higher. In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated).
StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
£1,429.99 inc VAT