Caddy 2K / 2KN H&R Deep shorter harder rear damper ( only for cars without headlight leveling )
Caddy 2K / 2KN H&R Deep shorter harder rear damper ( only for cars without headlight leveling )
£250.00 inc VAT
H&R Special Suspension Shortened Bilstein damper made for StillStatic , for use with deep suspension , or air suspension. The damper is fixed rate but harder than stock dampers helping to overcome wheel wobble common with leaf spring and beam set ups on caddys. Suitable for carrying weight. Priced per damper.
){kind=link}
H&R Deep Coilover Kit for VW Passat 32A:
Suspension, H&R Coilover Suspension, Shop by Car, Volkswagen, Passat, H&R Coilovers
£2,269.99 inc VAT
H&R Deep Coilover Kit for VW Beetle Type 16 09/11> ( 50mm Front Strut Clamp + Twist Beam Rear ) Lowering : 60-90mm
Suspension, H&R Coilover Suspension, Shop by Car, Volkswagen, Beetle, H&R Coilovers
H&R Deep Coilover to fit Beetle Type 16 with 55mm front hub diameter and twist beam rear suspension only.
Lowering is 60-90mm.
H&R Deep are monotube dampers with superior comfort and are supplied for use with original top mounts.
£1,695.00 inc VAT
£1,695.00 inc VAT
H&R Deep Coilover Kit for VW Polo 5 6R/6C1 very low 110mm
Suspension, H&R Coilover Suspension, Shop by Car, Volkswagen, Polo, H&R Coilovers
H&R Deep Coilover Kit for VW POLO 5 (6R1, 6C1) | 03/2009 >
Note: Prior to ordering check: Front top shock absorber fixation to the body with one nut, NOT for fixations with three bolts.
This version is -20mm shorter than GFW50015-1 which lowers 90mm max
Lowered front axle from [mm]: 80 • Lowering front axle up to [mm]: 100
Lowered rear axle from [mm]: 80 • Lowered rear axle up to [mm]: 110
This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary.
Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality.
Note: The picture may differ from the delivered product
£1,799.99 inc VAT
This version offers more lowering range than the normal H&R version.
The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited.
After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions.
If necessary, the vehicle ride height must be adjusted higher. In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated).
StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
£1,799.99 inc VAT