SRS-Tec 2cm Wider Wings GT, VW Polo 6R

SRS-Tec 2cm Wider Wings GT, VW Polo 6R

£449.99 inc VAT

Description

Manufacturer
SRS-Tec Article
Wide fender set GT (left & right) Area of use
Make: Volkswagen
Modell: Polo V
Type: 6R
Model Year: 03/2009 – 03/2014
Submodell: All
Engine: All

Details

Notice
2cm wider then the stock fenders. OEM Design.
Fenders are mounted without any modification on the front bumper. Expert’s report
German TÜV report Material
Made in Germany – GRP composite Product copyright
The copying of our parts and our designs will be prosecuted!

Assembly Instructions

Like the stock fenders, no modifications required.

Included

SRS-Tec wide fender set GT left & right (unpainted)
– TÜV report
– Fitting material
– Fitting instructions

Made to Order (contact us for lead time)

SKU: SRS-VWP6R-K01 Category:
000

    Recommended Products

    • £2,320.00 inc VAT

      HP Drivetech Air Suspension Kit for Volkswagen Polo – 6R (2008-2014)

      , , ,
      £2,320.00 inc VAT
    • £1,799.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R/6C1 very low 110mm

      , , , , ,
      £1,799.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R/6C1 very low 110mm

      , , , , ,
      H&R Deep Coilover Kit for VW POLO 5 (6R1, 6C1) | 03/2009 > Note: Prior to ordering check: Front top shock absorber fixation to the body with one nut, NOT for fixations with three bolts. This version is -20mm shorter than GFW50015-1 which lowers 90mm max Lowered front axle from [mm]: 80 • Lowering front axle up to [mm]: 100 Lowered rear axle from [mm]: 80 • Lowered rear axle up to [mm]: 110 This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary. Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality. Note: The picture may differ from the delivered product
      This version offers more lowering range than the normal H&R version. The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited. After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions. If necessary, the vehicle ride height must be adjusted higher.  In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated). StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
      £1,799.99 inc VAT
    • £1,249.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R / 6C1 ( 90mm )

      , , , , ,
      £1,249.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R / 6C1 ( 90mm )

      , , , , ,
      H&R Deep Coilover Kit for VW POLO 5 (6R1, 6C1) | 03/2009 > Note: Prior to ordering check: Front top shock absorber fixation to the body with one nut, NOT for fixations with three bolts. Lowered front axle from [mm]: 60 • Lowering front axle up to [mm]: 80 Lowered rear axle from [mm]: 60 • Lowered rear axle up to [mm]: 90 This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary. Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality. Note: The picture may differ from the delivered product
      This version offers more lowering range than the normal H&R version. The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited. After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions. If necessary, the vehicle ride height must be adjusted higher.  In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated). StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
      £1,249.99 inc VAT

    Recommended Products

    • £1,249.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R / 6C1 ( 90mm )

      , , , , ,
      £1,249.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R / 6C1 ( 90mm )

      , , , , ,
      H&R Deep Coilover Kit for VW POLO 5 (6R1, 6C1) | 03/2009 > Note: Prior to ordering check: Front top shock absorber fixation to the body with one nut, NOT for fixations with three bolts. Lowered front axle from [mm]: 60 • Lowering front axle up to [mm]: 80 Lowered rear axle from [mm]: 60 • Lowered rear axle up to [mm]: 90 This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary. Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality. Note: The picture may differ from the delivered product
      This version offers more lowering range than the normal H&R version. The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited. After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions. If necessary, the vehicle ride height must be adjusted higher.  In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated). StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
      £1,249.99 inc VAT
    • £2,320.00 inc VAT

      HP Drivetech Air Suspension Kit for Volkswagen Polo – 6R (2008-2014)

      , , ,
      £2,320.00 inc VAT
    • £1,799.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R/6C1 very low 110mm

      , , , , ,
      £1,799.99 inc VAT

      H&R Deep Coilover Kit for VW Polo 5 6R/6C1 very low 110mm

      , , , , ,
      H&R Deep Coilover Kit for VW POLO 5 (6R1, 6C1) | 03/2009 > Note: Prior to ordering check: Front top shock absorber fixation to the body with one nut, NOT for fixations with three bolts. This version is -20mm shorter than GFW50015-1 which lowers 90mm max Lowered front axle from [mm]: 80 • Lowering front axle up to [mm]: 100 Lowered rear axle from [mm]: 80 • Lowered rear axle up to [mm]: 110 This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary. Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality. Note: The picture may differ from the delivered product
      This version offers more lowering range than the normal H&R version. The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited. After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions. If necessary, the vehicle ride height must be adjusted higher.  In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated). StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
      £1,799.99 inc VAT