MTS Technik Coilover kit BMW 5 Series / E34 Saloon

MTS Technik Coilover kit BMW 5 Series / E34 Saloon

£820.00 inc VAT

Coilover Kit BMW 5 Series / E34 Sedan

Coilover Kit MTS Technik for BMW 5 Series / E34 Sedan, lowering the front axle between 20 – 95 mm, and rear between 20 – 85 mm. Dedicated for the years of: 01/88 – 12/95, for the engine version: 518i / 520i / 525i / 530i / 535i / 540i / 524td / 525tds / M5.

 

2 years warranty 2 year warranty with no mileage limit to confirm high quality.
High quality Suspension components characterized by increased corrosion resistance and made of the highest quality materials.
Twin-tube construction The use of twin-tube technology guarantees stable shock absorber performance.
Gas technology Pressurized gas presses the hydraulic fluid, eliminating the “foaming” effect of the oil (an undesirable and typical for oil shock absorbers phenomenon), which means higher efficiency for continuous, intensive work.
Specially selected type of thread Specially selected type of thread and a wide range of suspension adjustment allows optimal setting of the car height.
Top mounts with camber adjustment The camber plates allow the wheel angle adjustment and increase the precision of driving.
hexaCOIL adjustable spring perch Innovative hexaCOIL spring perch, significantly increasing the comfort of suspension height adjustment.
Independent height adjustment at the bottom mounting Additional height adjustment at the bottom mounting, allowing the car’s height reduction to be changed, without interfering with the spring operation characteristics.
Anti-corrosion protection yellow galvanized Double zinc plated steel shock absorbers as well as anodized aluminum adjusters and caps to ensure increased corrosion resistance.
Eibach springs Coilover springs made by Eibach, the world leader in the sport springs industry.
2 – Front and rear axle height adjustable (threaded shock absorber housing).
8 – Not for 4×4.
9 – Only for vehicles without NIVO / OEM pneumatic suspension.
21 – If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.
24 – During the installation of suspension set the clearance between tire/rim and suspension strut shall be checked. The minimum allowed gap is 5mm (0,2 inch). Otherwise use certificated wheel spacers.
26 – Independent height adjustment at the lower brackets on the front dampers.
28 – Set includes 2x upper “camber plates” on the front axle.
29 – The installation requires the use of OE front struts – they should be cut and welded as described in the attached manual.
33 – Including M-Technik.
Clear
000