HP Drivetech Air Suspension Kit for BMW 3 Gran Turismo xDrive – F34 (2013- )
HP Drivetech Air Suspension Kit for BMW 3 Gran Turismo xDrive – F34 (2013- )
£2,450.00 inc VAT
Made to Order (contact us for lead time)
){kind=link}
Muecke Audi A3 S3 8V Saloon wider wings 3cm ( inc facelift )
Shop by Car, Audi, A3 / S3 / RS3, Muecke-Carbon & Bodywork Parts ( Wider Wings )
When lowering a car, prime concern is clearance for the steering wheels. These quality Muecke wide wings are available for a variety of vehicles - in some cases in a variety of widths too.
Stated widths are per side
All of these wings are available in carbon fibre too, for an extra cost. Please contact us if this something you would like to look into, and would like a quote.
£449.00 inc VAT
- 1 set fiberglass front wing R+L for Audi A3 8v saloon widened 3 cm per side
- also fits facelift (8V2)
- unpainted, surface gelcoat gray
- Material report is included, acceptance according to §21 StVZO (individual acceptance)
- for saloon models only
£449.00 inc VAT
H&R Deep Coilover Kit for Audi S1 8X Quattro
Suspension, H&R Coilover Suspension, Shop by Car, Audi, H&R Coilovers
H&R Deep Coilover Kit for Audi S1 8X Quattro ( 170 KW ) 2014>
for vehicles without electronic suspension control
Lowered front axle from [mm]: 55 • Lowering front axle up to [mm]: 70
Lowered rear axle from [mm]: 40 • Lowered rear axle up to [mm]: 85
This kit is not supplied with top mounts , the original top mounts must be used or replaced if necessary.
Fixed damping monotube coilovers offered with Bilstein inserts H&R Linear Springs for ultimate comfort and ride quality.
Note: The picture may differ from the delivered product
£1,429.99 inc VAT
This version offers more lowering range than the normal H&R version.
The Product is a version that can achieve lowering beyond the H&R standard lowering adjustment range. Due to vehicle-specific tolerances, additional work & modifications may be necessary on the vehicle. Any of those arising costs incurred in this regard these will not be borne by StillStatic Limited.
After installation of coilover suspension, the clearance of drive shafts and the wheel/tyre combination to any kind of safety relevant parts, must be checked in all driving and max. load conditions.
If necessary, the vehicle ride height must be adjusted higher. In any case, however, the legally specified minimum ride heights on the vehicle must be observed (direction indicators, light beam angle etc calibrated).
StillStatic Limited accepts no liability for any damage that may occur as a result of non-compliance with the above points.
£1,429.99 inc VAT